|
General Description: A flexible white top coated polyester film coated with our low-tack long-term ultra removable GPC 20 adhesive and backed with a 1.5 mil polyester liner.
Application: GPC 1201 is designed for use in the wafer, semiconductor and disk drive industry. The surface can be printed on via thermal transfer, dot matrix or handwritten. It offers the highest levels of cleanliness (no adhesive transfer) and is typically used for shipper/carrier identification where ultra clean removability is imperative.
PRODUCT DATA
- Facestock: 2.00 mil +/- 10% polyester
- Adhesive thickness: 0.9 - 1.0 mils
- Liner: 1.5 mil polyester +/- 10%
Adhesive Properties:
| Adhesion Peel Test (PSTC-1) |
Polycarbonate |
Polypropylene |
| Initial |
5 oz/in |
3 oz/in |
| Ultimate |
10 oz/in |
7 oz/in |
| Tack (Polyken) ASTM D-297 |
9 25 g/sq cm |
|
Service Temperature Range: -20°F to 175°F with minimum application temperature 50°F Test results of water, humidity and solvent stability are reduced due to the low tack of this adhesive. GPC 1201 is not recommended when subjected to:
- Lower alkyl alcohols
- Hot oil
- Lower aliphatic hydrocarbons (gasoline)
- Water submergence
The above data represents product averages, allowing for industry-accepted variances. This construction should be tested in the end-use conditions to insure that it meets the requirements of the specific application. Suitability for any given application is the responsibility of the user.
Genesis PC 5699 SE International Way Suite J Milwaukie, OR 97222
Phone: 503-652-2545 Fax: 503-652-2475 www.genesislabels.com GPC1201-B
|